While drum brakes do have a completely different layout and mode of operation than disc brakes, they are usually no more difficult to service, and often require only a basic set of hand tools and a bit of elbow grease.
Table of Contents
How long does a rear drum brake job take?
Replacing a pair of drums and shoes takes about two hours on average. It can take longer if you need to replace other components as well. Since drum brakes last so long, it’s a good idea to replace the wheel cylinder, adjuster, and springs when you replace the drums.
Do you have to bed drum brakes?
When new pads or brake rotors/discs are installedor new brake shoes and/or drums, you must carefully and properly bed these new items in to prevent problems. This is accomplished by proper bedding.
What are the 2 types of drum brakes?
The leading or trailing drum brake is the most common type of brake on a drum. It is used to stop the drum from moving forward or backward. The drum is held in place by the leading shoe, and the trailing shoe is pressed against it. This is a very simple and effective brake, but it is not the best choice for all applications.
For example, if you have a large drum, you may want to use a trailing or leading brake. If you are using a smaller drum and need to slow down or stop quickly, then you should use only a single leading, trailing, or double trailing brake shoe.
In this case you will have to make sure that you use the correct size drum for the application, as well as the right size shoes for each drum type. You should also be careful not to over-tighten the shoes, which can lead to a loss of braking power.
A good rule of thumb to remember is that the larger the diameter of your drum the more likely it will be to be damaged by excessive wear and tear.
Do you have to bleed drum brakes after replacing shoes?
Air can enter the master cylinder when you replace worn brake pads. The space for air is created by the drain of the brake fluid and the worn pads. You can change your pads or rotors. Any brake job should include a brake bleed for this reason.
What are the parts of a drum brake?
The backing plate, brake drum, shoe, wheel cylinder, and various parts of the brake system are included in the drum brake components. The drum brake is the most common type of brake on a motorcycle.
The drum brakes are made of steel and are used to control the speed of a motorcyclist when the motorcycle is in motion. Drum brakes can be used on all types of motorcycles, but they are most commonly found on sport bikes and sport utility vehicles (SUVs).
Do you need special tools to change drum brakes?
You will need a drum brake retainer spring tool and a pair of drum brake spring pliers. These can be purchased as a set. Simple tools like a hammer, pliers, and other hand tools are needed to get the job done. If you don’t already have these tools, you can get them at any hardware store. If you do have them, make sure they’re the right size for your brake.
The larger the brake, the more difficult it will be to remove. Also, be sure to use the correct size brake for the type of brake lever you’re using. For example, if you have a brake with a large lever, then you’ll want a smaller brake that will fit on the smaller lever.
How much does it cost to replace rear drum brakes?
Depending on the type of vehicle you have the repair done on, the average cost for a brake drum replacement is between $275 and $400. If you are looking to replace your brake drums, you will need to have your vehicle inspected by a qualified mechanic to ensure that your brakes are in good working order.
You will also want to make sure that the brake pads and rotors are clean and free of dirt and debris.
