The top nut of the violin and viola can be used with a violin knife. Place the top nut in either corner, shake it gently and apply downward pressure, and squeeze across the seam and around the edge of the nut. If you are using a violin, you will need to remove the strings from the instrument.
You can do this with a small pair of pliers, or with your fingernail. If you do not have a plier, use your fingers to gently pull the string through the hole in the neck. Be careful not to pull too hard, as you may damage the wood.
Table of Contents
How do you remove nut from violin?
I used a very thin knife to ply the fingerboard off, and then the nut came off with it. I thought using a thin, sharp knife would be the best way to remove the nut, but I didn’t have one. The nut was a bit of a pain to get out of the case. I had to use a pair of pliers to hold it in place while I pulled it out.
Once it was out, it took a few tries to figure out how to put it back in. It took me a couple of tries before I got it right. The first time I tried, the screw that held it to the board was too tight and I couldn’t get it all the way out with my fingers. I realized that I was holding it too tightly and it wouldn’t come out at all.
I loosened it up a little and tried again. This time it came out just fine. I figured out the right amount of pressure to apply to push it through the hole in the back, all that was left was to screw it into place with a screwdriver. This is what it looks like when it’s all put together.
When should I take the tape off my violin?
As soon as possible, get the tapes off. The short answer is “immediately, if not before”. You’re not going to be able to hear the difference between the right and the wrong notes if you wash your ears. If you don’t know, you’ll never know.
What kind of glue is used for violins?
Hide glue is a standard glue used by violin makers and is prized for its ability to be dissolved to remove a plate or other part of the instrument. Gluing is also used to attach strings to a violin, but it is not the same as glue.
It is made from a mixture of polyvinyl chloride (PVC) and polyurethane (PU). PVC is dissolved in a solvent and the PU is added to the solvent. The solvent is then evaporated, leaving a residue of PVC and PU that can be easily removed by hand or machine.
What is a violin nut?
A nut on a stringed musical instrument is a small piece of hard material that supports the strings at the end closest to the body of the instrument. The nut is usually made of wood, but can also be made out of metal or plastic. The term “nut” is also used to refer to any of a number of other types of musical instruments, such as a guitar, mandolin, banjo, or ukulele.
Do violins have a nut?
The violin nut is a tiny piece of the violin and it’s important to the instrument’s sound and playability. Your instrument won’t come out of tune if it’s made or installed incorrect.
How high should a violin nut be?
The correct measurement at the middle of the upper string is 3.5mm for a violin, 4.5mm for a viola, and 5.5mm for an obo. In the case of a double-stringed instrument, the measurement should be taken from the lowest string to the highest string.
For example, if the instrument is a bass, it should have a measurement of 4 mm. If it’s a treble, then it would have to be measured at 5 mm and so on.
